Prusa i3 ZAxis won't "Auto Home" or register the endstop (And

Prusa Callibrate Z Failed. Prusa I3 Nozzle Hit Bed Calibrate Z YouTube sensor must stop right in the center of the 1st and also the last calibration point (please refer to photos below). If you load the MK3S/MK2.5S firmware in the MK3/MK2.5 (non S) machine, the calibration will keep on failing, because the length of the Z-axis coded in both firmware differs

sensor must stop right in the center of the 1st and also the last calibration point (please refer to photos below). To be clear: For the X-Y part of the XYZ calibration you use the paper as you indicated but you have to add the steel sheet before proceeding with the Z part of it (I think the display will prompt you to add it).

Cannot calibrate Z axis Assembly and first prints troubleshooting

Wiring issue Make sure there is not a wiring-issue with the X/Y end-stop on the mini RAMBo… To be clear: For the X-Y part of the XYZ calibration you use the paper as you indicated but you have to add the steel sheet before proceeding with the Z part of it (I think the display will prompt you to add it). If you load the MK3S/MK2.5S firmware in the MK3/MK2.5 (non S) machine, the calibration will keep on failing, because the length of the Z-axis coded in both firmware differs

Cannot calibrate Z axis Assembly and first prints troubleshooting. Through 170+ hours of intensive testing, our engineering team assessed how this. After checking the 1st calibration point, move the extruder with your hand, to the other end of the heatbed and inspect the 2nd calibration point.

Cannot calibrate Z axis Assembly and first prints troubleshooting. RE: calibration failed! check the axes and try again RE: Calibration Failed! Check the axes and run again